Jeep Wrangler 2018-2026 Owners Manual

Jeep Wrangler 2018-2026 Owners Manual

Owners Manual for the fourth generation Jeep Wrangler, a compact four-wheel drive off-road SUV, manufactured by Jeep, model years 2018-2026. This is a specialized utility vehicle. It can go places and perform tasks that are not intended for conventional passenger vehicles. It handles and maneuvers differently from many passenger vehicles both on-road and off-road, so take time to become familiar with your vehicle. If equipped, the two-wheel drive version of this vehicle was designed for on-road use only. It is not intended for off-road driving or use in other severe conditions suited for a four-wheel drive vehicle. Before you start to drive this vehicle, read this Owner’s Manual.

Find your English level with this short quiz.

Jeep Wrangler 2018-2026 Owners Manual

INTRODUCTION

..

Other information:

Jeep Wrangler 2018-2026 Owners Manual: Tire Pressure Monitoring System (TPMS)


The Tire Pressure Monitoring System (TPMS) will warn the driver of a low tire pressure based on the vehicle recommended cold placard pressure. NOTE: The alert warning on the cluster will stay on until the tire is inflated to the placard pressure. The tire pressure will vary with temperature by approximately 1 psi (7 kPa) for every 12°F (6...

Jeep Wrangler 2018-2026 Owners Manual: Installing Child Restraints Using The Top Tether Anchorage


WARNING! Do not attach a tether strap for a rear-facing car seat to any location in front of the car seat, including the seat frame or a tether anchorage. Only attach the tether strap of a rear-facing car seat to the tether anchorage that is approved for that seating position, located behind the top of the vehicle seat...

Categories

Erasing All The HomeLink® Channels

To erase the channels, follow this procedure:

Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes.

NOTE:

Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming additional buttons.

read more

 
Copyright © 2026 www.jewrangler.com