Jeep Wrangler: MULTIMEDIA / UCONNECT INTRODUCTION
The Uconnect system uses a combination of
buttons on the touchscreen and buttons on the
faceplate located on the center of the
instrument panel. These buttons allow you to
access and change the Customer
Programmable Features...
Uconnect 3 With 5-inch Display
Radio Button
Media Button
Phone Button
Volume & On/Off Button
Mute Button
Compass Button
Settings Button
More Button
Enter/Browse & Tune/Scroll Knob
Screen Off Button
Uconnect 4 With 7-inch Display
Radio Button
Media Button
Climate Button
Apps Button
Controls Button
Phone Button
Settings Button
NOTE:
Uconnect screen images are for illustration
purposes only and may not reflect exact software
for your vehicle...
Other information:
The transmission gear range (PRNDM) is
displayed both beside the gear selector and in
the instrument cluster. To select a gear range,
push the lock button on the gear selector and
move the selector rearward or forward. To shift
the transmission out of PARK, the engine must
be running and the brake pedal must be pressed...
The ENGINE START/STOP button operates
similar to an ignition switch. It has three modes:
OFF, ACC, and RUN. To change the ignition
modes without starting the vehicle and use the
accessories, follow these steps:
Start with the ignition in the OFF mode...
Categories
To erase the channels, follow this procedure:
Place the ignition switch into the ON/RUN
position.
Push and hold the two outside HomeLink®
buttons (I and III) for up to 20 seconds, or
until the HomeLink® indicator light flashes.
NOTE:
Erasing all channels should only be performed
when programming HomeLink® for the first
time. Do not erase channels when programming
additional buttons.
read more