Jeep Wrangler: Manual Adjustment Front Seats / Manual Front Seat Recline Adjustment
To recline the seat, pull on the recline strap and lean forward or backward, depending on the direction you would like the seatback to move. Release the strap when the desired position is reached and the seatback will lock into place.
Recline Strap
WARNING!
Do not ride with the seatback reclined so that the shoulder belt is no longer resting against your chest. In a collision you could slide under the seat belt, which could result in serious injury or death.
Manual Seat Height Adjustment
The driver's seat height can be raised or
lowered by using the ratcheting handle, located
on the outboard side of the seat. Pull upward on
the handle to raise the seat, push downward on
the handle to lower the seat...
Lumbar Support
The lumbar control knob is located on the
outboard side of the front driver seat. Rotate
the control forward to increase and rearward to
decrease the desired amount of lumbar
support...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Installing The Soft Top Windows
Install The Right And Left Quarter Windows From the rear of the vehicle, guide the top of the window into the retainer and slide forward while keeping the window level. Repeat on the other side. Step One Place the top of the quarter window pillar into the top cover, and insert the bottom tab into the clip...
Jeep Wrangler 2018-2026 Owners Manual: FUEL REQUIREMENTS – DIESEL ENGINE
Federal law requires that you must fuel this vehicle with Ultra Low Sulfur Highway Diesel fuel (15 ppm Sulfur maximum) and prohibits the use of Low Sulfur Highway Diesel fuel (500 ppm Sulfur maximum) to avoid damage to the emissions control system...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- SERVICING AND MAINTENANCE
- Manual Seat Height Adjustment
- Engine Coolant Level — 2.0L
- New on site
- Most important about car
Automatic Headlights — If Equipped, Lights-On Reminder
Automatic Headlights
This system automatically turns the headlights on or off according to ambient light levels. To turn the system on, rotate the headlight switch clockwise to the last detent for automatic headlight operation. When the system is on, the headlight time delay feature is also on. This means the headlights will stay on for up to 90 seconds after you place the ignition into the OFF position. To turn the automatic system off, move the headlight switch out of the AUTO position.
