Jeep Wrangler: EXTERIOR LIGHTS / Automatic Headlights — If Equipped, Lights-On Reminder
Automatic Headlights
This system automatically turns the headlights
on or off according to ambient light levels. To
turn the system on, rotate the headlight switch
clockwise to the last detent for automatic
headlight operation. When the system is on, the
headlight time delay feature is also on. This
means the headlights will stay on for up to
90 seconds after you place the ignition into
the OFF position. To turn the automatic
system off, move the headlight switch out of the
AUTO position.
NOTE:
The engine must be running before the headlights
will come on in the automatic mode.
Lights-On Reminder
If the headlights, parking lights, or cargo lights
are left on after the ignition is placed in the OFF
position, a chime will sound when the driver’s
door is opened.
Automatic High Beam Headlamp Control
The Automatic High Beam Headlamp Control
system provides increased forward lighting at
night by automatically controlling the high
beams through the use of a camera mounted
on the vehicle’s header...
To activate the Front Fog Lights, turn on the
parking lights or low beam headlights and push
the fog light switch. Pushing the fog light switch
a second time will turn the front fog lights off...
Other information:
NOTE:
See an authorized dealer for LED bulb replacement.
NOTE:
Lens fogging can occur under certain atmospheric
conditions. This will usually clear as
atmospheric conditions change to allow the
condensation to change back into a vapor.
Turning the lamps on will usually accelerate the
clearing process...
SSC is intended for off-road
driving in
4WD Low only. SSC maintains vehicle
speed by actively controlling engine
torque and brakes.
SSC has three states:
Off (feature is not enabled and will not
activate)
Enabled (feature is enabled and ready but
activation conditions are not met, or driver
is actively overriding with brake or throttle
application)
Active (feature is enabled and actively
controlling vehicle speed)
Enabling SSC
SSC is enabled by pushing the SSC switch, but
the following conditions must also be met to
enable SSC:
The driveline is in 4WD Low...