Jeep Wrangler: EXTERIOR LIGHTS / Automatic High Beam Headlamp Control — If Equipped, Flash-To-Pass
Automatic High Beam Headlamp Control
The Automatic High Beam Headlamp Control
system provides increased forward lighting at
night by automatically controlling the high
beams through the use of a camera mounted
on the vehicle’s header. This camera detects
vehicle specific light and automatically switches
from high beams to low beams until the
approaching vehicle is out of view.
NOTE:
- The Automatic High Beam Headlamp Control
can be turned on or off by selecting “ON”
under “Auto High Beam” within your
Uconnect Settings, as well as
turning the headlight switch to the AUTO position
and placing the multifunction lever in the
high beam position.
- Broken, muddy, or obstructed headlights and
taillights of vehicles in the field of view will
cause headlights to remain on longer (closer
to the vehicle). Also, dirt, film, and other
obstructions on the windshield or camera
lens will cause the system to function improperly.
Flash-To-Pass
You can signal another vehicle with your
headlights by lightly pulling the multifunction
lever toward you. This will cause the high beam
headlights to turn on, and remain on, until the
lever is released.
Push the multifunction lever toward the
instrument panel to switch the headlights to
high beams. The lever will return to the centered
position. To return the headlights to low beam,
pull the lever toward the steering wheel, or push
the lever toward the instrument panel...
Automatic Headlights
This system automatically turns the headlights
on or off according to ambient light levels. To
turn the system on, rotate the headlight switch
clockwise to the last detent for automatic
headlight operation...
Other information:
Fluid Level Check
The fluid level should be to the bottom edge of
the fill hole when the vehicle is in a level
position.
Transfer Case
Fill hole
Drain hole
Drain And Refill
For the proper maintenance intervals.
Selection Of Lubricant
Use only the manufacturer recommended fluid...
This warning light monitors
various
brake functions, including brake fluid
level and parking brake application. If
the brake light turns on it may
indicate that the parking brake is applied, that
the brake fluid level is low, or that there is a
problem with the Anti-Lock Brake System
reservoir...