Jeep Wrangler: EXTERIOR LIGHTS / High/Low Beam Switch

Push the multifunction lever toward the instrument panel to switch the headlights to high beams. The lever will return to the centered position. To return the headlights to low beam, pull the lever toward the steering wheel, or push the lever toward the instrument panel.

Jeep Wrangler. High/Low Beam Switch

Multifunction Lever

    Daytime Running Lights (DRLs) — If Equipped

    The Daytime Running Lights are in a dedicated position below the headlight assembly. DRLs are active when the low beams are not on, and the engine is running...

    Automatic High Beam Headlamp Control — If Equipped, Flash-To-Pass

    Automatic High Beam Headlamp Control The Automatic High Beam Headlamp Control system provides increased forward lighting at night by automatically controlling the high beams through the use of a camera mounted on the vehicle’s header...

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: Run Flat Tires — If Equipped


    Run Flat tires allow you the capability to drive 50 miles (80 km) at 50 mph (80 km/h) after a rapid loss of inflation pressure. This rapid loss of inflation is referred to as the Run Flat mode. A Run Flat mode occurs when the tire inflation pressure is of/or below 14 psi (96 kPa)...

    Jeep Wrangler 2018-2026 Owners Manual: Safety Guidelines


    WARNING! ALWAYS drive safely with your hands on the steering wheel. You have full responsibility and assume all risks related to the use of the Uconnect features and applications in this vehicle. Only use Uconnect when it is safe to do so. Failure to do so may result in an accident involving serious injury or death...

    Categories

    Remote Start system

    Jeep Wrangler. Remote Start system This system uses the key fob to start the engine conveniently from outside the vehicle while still maintaining security. The system has a range of approximately 300 ft (91 m).

    read more

     
    Copyright © 2026 www.jewrangler.com