Jeep Wrangler: Manual Adjustment Front Seats / Manual Seat Height Adjustment
The driver's seat height can be raised or
lowered by using the ratcheting handle, located
on the outboard side of the seat. Pull upward on
the handle to raise the seat, push downward on
the handle to lower the seat. Several strokes
may be necessary to achieve the desired
position.

Seat Height Adjustment
The seat can be adjusted forward or rearward
by using a bar located by the front of the seat
cushion, near the floor. While sitting in the seat,
lift up on the bar located under the seat cushion
and move the seat forward or rearward...
To recline the seat, pull on the recline strap and
lean forward or backward, depending on the
direction you would like the seatback to move.
Release the strap when the desired position is
reached and the seatback will lock into place...
Other information:
Fluid Level Check
The fluid level should be to the bottom edge of
the fill hole when the vehicle is in a level
position.
Transfer Case
Fill hole
Drain hole
Drain And Refill
For the proper maintenance intervals.
Selection Of Lubricant
Use only the manufacturer recommended fluid...
Remove the rear seats.
Remove the sides grommets (one left and
one right). First the grommet from the side
carpet and then the rear carpet.
Side Carpet
Remove the grommets under the front seat
(one left and one right).
Then pull the carpet out to the rear and
open the carpet split around the front seats
brackets...