Jeep Wrangler: Manual Adjustment Front Seats / Lumbar Support

Manual Front Seat Recline Adjustment

To recline the seat, pull on the recline strap and lean forward or backward, depending on the direction you would like the seatback to move. Release the strap when the desired position is reached and the seatback will lock into place...

Front Passenger Easy Entry Seat — Two Door Models

Pull upward on the easy entry lever located on the outboard side of the seat back, and slide the entire seat forward. Easy Entry Lever To return the seat to a sitting position, fold the seatback upright until it locks and push the seat rearward until the track locks...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: Auxiliary Switches — If Equipped

Four auxiliary switches located in the lower switch bank of the instrument panel can be used to power various electrical devices. You have the ability to configure the functionality of the auxiliary switches via the Uconnect Settings. All switches can be configured as follows: Switch type operation: Latching or Momentary Power source: Battery or Ignition Ability to hold last state across key cycles: On or Off Auxiliary Switches NOTE: Holding last state conditions are met when switch type is set to latching and power source is set to ignition...

Jeep Wrangler 2018-2026 Owners Manual: Front/Rear Axle Fluid

For normal service, periodic fluid level checks are not required. When the vehicle is serviced for other reasons the exterior surfaces of the axle assembly should be inspected. If gear oil leakage is suspected inspect the fluid level. Fluid Level Check Lubricant should be approximately 1/8 inch (3 mm) below the bottom edge of the oil fill hole...