Jeep Wrangler: GETTING TO KNOW YOUR VEHICLE / INTERIOR LIGHTS
Turn Signals
Move the multifunction lever up or down to
activate the turn signals. The arrows on each
side of the instrument cluster flash to show
proper operation...
The courtesy lights will turn on when the front
doors are opened, by rotating the dimmer
controls on the headlight switch fully upward,
or, if equipped, when the unlock button is
pushed on the key fob...
Other information:
Use Mopar® Total Clean to clean vinyl
upholstery.
CAUTION!
Direct contact of air fresheners, insect
repellents, suntan lotions, or hand sanitizers
to the plastic, painted, or decorated
surfaces of the interior may cause permanent
damage. Wipe away immediately...
Once you have activated your services, you’re
only a few steps away from using connected
services.
Uconnect Mobile App
Settings
Vehicle Info
Location And Send & Go
Remote Commands
Download the Uconnect app to your mobile
device.
Use your Owner Account login and password
to open the app and then set up a PIN...
Categories
To erase the channels, follow this procedure:
Place the ignition switch into the ON/RUN
position.
Push and hold the two outside HomeLink®
buttons (I and III) for up to 20 seconds, or
until the HomeLink® indicator light flashes.
NOTE:
Erasing all channels should only be performed
when programming HomeLink® for the first
time. Do not erase channels when programming
additional buttons.
read more