Jeep Wrangler: EXTERIOR LIGHTS / Turn Signals. Lane Change Assist — If Equipped
Turn Signals
Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation.
NOTE:
If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb.
Lane Change Assist — If Equipped
Lightly push the multifunction lever up or down, without moving beyond the detent, and the turn signal will flash three times then automatically turn off.
Front Fog Lights — If Equipped
To activate the Front Fog Lights, turn on the
parking lights or low beam headlights and push
the fog light switch. Pushing the fog light switch
a second time will turn the front fog lights off...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Things You Should Know About Uconnect Phone
Voice Command For the best performance: Always wait for the beep before speaking Speak normally, without pausing, just as you would speak to a person sitting a few feet/ meters away from you Ensure that no one other than you is speaking during a voice command period Low-To-Medium Blower Setting Low-To-Medium Vehicle Speed Low Road Noise Smooth Road Surface Fully Closed Windows Dry Weather Conditions WARNING! ALWAYS drive safely with your hands on the wheel...
Jeep Wrangler 2018-2026 Owners Manual: Seat Belts And Pregnant Women
Seat Belts And Pregnant Women Seat belts must be worn by all occupants including pregnant women: the risk of injury in the event of an accident is reduced for the mother and the unborn child if they are wearing a seat belt. Position the lap belt snug and low below the abdomen and across the strong bones of the hips...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Service 4WD Warning Light — If Equipped
- How To Use Remote Start
- The ASSIST and SOS Call Buttons On Your Rearview Mirror Or Overhead Console
- New on site
- Most important about car
Manual Front Seat Forward/Rearward Adjustment
The seat can be adjusted forward or rearward by using a bar located by the front of the seat cushion, near the floor. While sitting in the seat, lift up on the bar located under the seat cushion and move the seat forward or rearward. Release the bar once you have reached the desired position. Then, using body pressure, move forward and rearward on the seat to be sure that the seat adjusters have latched.
Adjustment Bar Location
