Jeep Wrangler: JACKING AND TIRE CHANGING / Jack Location
The jack and lug wrench are located in the rear
cargo area. To remove jack and tools proceed
as follows:
- Lift the load floor in the cargo area.

Load Floor
NOTE:
The load floor can be removed for easier access
by pulling the load floor directly rearward.
- Remove the hardware storage cover by
pinching the latch on the left side and
pulling upward.

Hardware Storage Cover Latch
- Turn the plastic wing nut counterclockwise
to loosen the jack from the storage bin.

Plastic Wing Nut Location
- Remove tool kit and assemble tools.
Park on a firm, level surface. Avoid ice or
slippery areas.WARNING!
Do not attempt to change a tire on the side of
the vehicle close to moving traffic...
To remove the spare tire from the carrier,
remove the tire cover, if equipped.
Remove the Rear Camera Cover by turning
the lock bolt counterclockwise with the
#T40 torx head driver and ratchet from the
supplied tool kit...
Other information:
Use Mopar® Total Clean to clean fabric
upholstery and carpeting.
WARNING!
Do not use volatile solvents for cleaning
purposes. Many are potentially flammable,
and if used in closed areas they may cause
respiratory harm.
Seat Belt Maintenance
Do not bleach, dye or clean the belts with
chemical solvents or abrasive cleaners...
A maximum blend of 5% biodiesel meeting
ASTM specification D975 is recommended for
use with your diesel engine. If frequent
operation with Biodiesel blends that are
between 6% and 20% (B6–B20) is desired, the
maintenance schedule is subject to shorter
intervals...