Jeep Wrangler: INTERIOR LIGHTS / Interior Courtesy Lights

The courtesy lights will turn on when the front doors are opened, by rotating the dimmer controls on the headlight switch fully upward, or, if equipped, when the unlock button is pushed on the key fob.

The interior courtesy lights are located in the center of the vehicle’s sport bar, and consist of one large center light and four smaller reading lights. Each reading light can be turned on by pushing the lens. Pushing the lens a second time will turn the light off.

Jeep Wrangler. Interior Courtesy Lights

Dome Lights

When a door is open and the interior lights are on, rotating the dimmer control to the extreme bottom position will cause all the interior lights to turn off. This is also known as “Party” mode because it allows the doors to stay open for extended periods of time without discharging the vehicle’s battery.

    INTERIOR LIGHTS

    ..

    Dimmer Controls

    Dimmer Controls Ambient Light Dimmer Control Instrument Panel Dimmer Control With the parking lights or headlights on, rotating the right dimmer control upward will increase the brightness of the instrument panel lights...

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: Remote Start Cancel Message


    The following messages will display in the instrument cluster if the vehicle fails to Remote Start or exits Remote Start prematurely: Remote Start Cancelled — Door Open Remote Start Cancelled — Hood Open Remote Start Cancelled — Fuel Low Remote Start Cancelled — Swing Gate Open Remote Start Cancelled — Time Expired Remote Start Disabled — Start Vehicle To Reset The message will stay active until the ignition is placed in the ON/RUN position...

    Jeep Wrangler 2018-2026 Owners Manual: Remote Vehicle Start


    Description The Remote Vehicle Start feature provides you with the ability to start the engine on your vehicle without the keys and from virtually any distance. Once started, the preset climate controls in your vehicle can warm up or cool down the interior...

    Categories

    Turn Signals. Lane Change Assist — If Equipped

    Turn Signals

    Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation.

    NOTE:

    If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb.

    read more

     
    Copyright © 2026 www.jewrangler.com