Jeep Wrangler: Blue Indicator Lights / High Beam Indicator Light
This indicator light will
illuminate to
indicate that the high beam
headlights are on. With the low beams
activated, push the multifunction
lever forward (toward the front of the vehicle) to
turn on the high beams. Pull the multifunction
lever rearward (toward the rear of the vehicle) to turn off the high beams. If
the high beams are
off, pull the lever toward you for a temporary
high beam on, "flash to pass" scenario.
Gray Indicator Lights
Cruise Control Ready Indicator Light — If Equipped With Base Instrument
Cluster
This light will turn on when the
Cruise
Control has been turned on, but not
set...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Tread Wear Indicators
Tread wear indicators are in the original equipment tires to help you in determining when your tires should be replaced. Tire Tread Worn Tire New Tire These indicators are molded into the bottom of the tread grooves. They will appear as bands when the tread depth becomes a 1/16 of an inch (1...
Jeep Wrangler 2018-2026 Owners Manual: Washing
Wash your vehicle regularly. Always wash your vehicle in the shade using Mopar® Car Wash, or a mild car wash soap, and rinse the panels completely with water. If insects, tar, or other similar deposits have accumulated on your vehicle, use Mopar® Super Kleen Bug and Tar Remover to remove...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Draining Fuel/Water Separator Filter — Diesel Engine
- Jack Location
- 2.0L Engine and 3.6L Engine
- New on site
- Most important about car
Automatic Headlights — If Equipped, Lights-On Reminder
Automatic Headlights
This system automatically turns the headlights on or off according to ambient light levels. To turn the system on, rotate the headlight switch clockwise to the last detent for automatic headlight operation. When the system is on, the headlight time delay feature is also on. This means the headlights will stay on for up to 90 seconds after you place the ignition into the OFF position. To turn the automatic system off, move the headlight switch out of the AUTO position.
