Jeep Wrangler: WARNING LIGHTS AND MESSAGES / Gray Indicator Lights
Cruise Control Ready Indicator Light — If Equipped With Base Instrument
Cluster
This light will turn on when the
Cruise
Control has been turned on, but not
set.
This indicator light will
illuminate to
indicate that the high beam
headlights are on. With the low beams
activated, push the multifunction
lever forward (toward the front of the vehicle) to
turn on the high beams...
Your vehicle is equipped with a sophisticated
Onboard Diagnostic system called OBD II. This
system monitors the performance of the
emissions, engine, and transmission control
systems...
Other information:
WARNING!
You or others could be injured if you leave the
vehicle unattended without having the
parking brake fully applied. The parking brake
should always be applied when the driver is
not in the vehicle, especially on an incline.
CAUTION!
Never drive with your foot resting on the
clutch pedal, or attempt to hold the vehicle
on a hill with the clutch pedal partially
engaged, as this will cause abnormal wear
on the clutch...
Remove the rear window and quarter panel
windows.
From the Sunrider® position,
remove straps if previously secured and
move to the rear of the vehicle.
Locate the Sunrider® latch beneath the #6
Bow of the soft top on the left side.
Step Three
Pull the latch to release the top, and allow
the soft top to slide rearward freely in the
guide tracks to the stowed position...