Jeep Wrangler 2018-2026 Owners Manual / GETTING TO KNOW YOUR INSTRUMENT PANEL
Jeep Wrangler: GETTING TO KNOW YOUR INSTRUMENT PANEL
- Wrangler Instrument Cluster
- INSTRUMENT CLUSTER DISPLAY
- Instrument Cluster Display Location And Controls
- Oil Change Reset — If Equipped
- Instrument Cluster Display Menu Items
- Battery Saver On/Battery Saver Mode Message — Electrical Load Reduction Actions — If Equipped
- Diesel Displays
- Diesel Particulate Filter (DPF) Messages
- Fuel System Messages
- WARNING LIGHTS AND MESSAGES
- Red Warning Lights
- Yellow Warning Lights
- Yellow Indicator Lights
- Green Indicator Lights
- White Indicator Lights
- Blue Indicator Lights
- Gray Indicator Lights
- ONBOARD DIAGNOSTIC SYSTEM — OBD II
- EMISSIONS INSPECTION AND MAINTENANCE PROGRAMS
ROOF LUGGAGE RACK — IF EQUIPPED
NOTE:
Roof rack applications are for Hard Top models
ONLY.
The load carried on the roof, when equipped
with a luggage rack, must not exceed 100 lb
(45 kg), this includes the weight of the
crossbars, and it should be uniformly
distributed over the cargo area...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Shifting Into (N) Neutral
Use the following procedure to prepare your vehicle for recreational towing: WARNING! You or others could be injured or killed if you leave the vehicle unattended with the transfer case in the (N) Neutral position without first fully engaging the parking brake...
Jeep Wrangler 2018-2026 Owners Manual: Rear Seat Armrest — If Equipped
The center part of the rear seat can also be used as a rear armrest with cupholders. To unfold it, grab the pull strap under the head restraint and pull it forward. Rear Seat Armrest NOTE: The cupholder liner can be removed for cleaning. WARNING! Be certain that the seatback is securely locked into position...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Auxiliary Switches — If Equipped
- SERVICING AND MAINTENANCE
- Automatic High Beam Headlamp Control — If Equipped, Flash-To-Pass
- New on site
- Most important about car
Basic Voice Commands
The basic Voice Commands below can be given at any point while using your Uconnect system. Push the VR button on the steering wheel. After the beep, say:
“Cancel” to stop a current voice session. “Help” to hear a list of suggested Voice Commands. “Repeat” to listen to the system prompts again.
Copyright © 2026 www.jewrangler.com