Jeep Wrangler: INSTRUMENT CLUSTER DISPLAY / Diesel Displays
When the appropriate conditions exist, the following messages display in the instrument cluster display:
- Exhaust Filter Nearing Full Safely Drive at Consistent Speeds to Clear
- Exhaust Filter Full – Power Reduced See Dealer
- Exhaust System Service Required – See Dealer
- Exhaust System – Filter XX% Full Service Required See Dealer
- Exhaust System Regeneration in Process Continue Driving
- Exhaust System – Regeneration Completed
Battery Saver On/Battery Saver Mode Message — Electrical Load Reduction
Actions — If Equipped
This vehicle is equipped with an Intelligent
Battery Sensor (IBS) to perform additional
monitoring of the electrical system and status
of the vehicle battery...
Diesel Particulate Filter (DPF) Messages
This engine meets all required diesel engine
emissions standards. To achieve these
emissions standards, your vehicle is equipped
with a state-of-the-art engine and exhaust
system...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Jack Location
The jack and lug wrench are located in the rear cargo area. To remove jack and tools proceed as follows: Lift the load floor in the cargo area. Load Floor NOTE: The load floor can be removed for easier access by pulling the load floor directly rearward...
Jeep Wrangler 2018-2026 Owners Manual: Driving In Snow, Mud And Sand
Snow In heavy snow or for additional control and traction at slower speeds, shift the transmission into a low gear and the transfer case into 4WD Low if necessary. Do not shift to a lower gear than necessary to maintain headway. Over-revving the engine can spin the wheels and traction will be lost...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Auxiliary Switches — If Equipped
- How To Use Remote Start
- UCONNECT SETTINGS
- New on site
- Most important about car
Turn Signals. Lane Change Assist — If Equipped
Turn Signals
Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation.
NOTE:
If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb.
Copyright © 2026 www.jewrangler.com