Jeep Wrangler: WARNING LIGHTS AND MESSAGES / Yellow Warning Lights

Vehicle Security Warning Light — If Equipped

This light will flash at a fast rate for approximately 15 seconds when the Vehicle Security system is arming, and then will flash slowly until the vehicle is disarmed...

Anti-Lock Brake System (ABS) Warning Light

This warning light monitors the ABS. The light will turn on when the ignition is placed in the ON/RUN or ACC/ON/ RUN position and may stay on for as long as four seconds...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: Power Door Locks — If Equipped


The power door lock switch is located on each front door panel. Push the switch forward to unlock the doors, and rearward to lock the doors. Power Door Lock Switch WARNING! For personal security reasons and safety in a collision, lock the vehicle doors when you drive, as well as when you park and exit the vehicle...

Jeep Wrangler 2018-2026 Owners Manual: Carpet Safety Information


Always use carpet designed to fit your vehicle. Only use carpet that does not interfere with the operation of the pedal assemblies. Only operate the vehicle when the carpet is securely attached by the grommets so it cannot slip out of position and interfere with the pedal assemblies or impair safe operation of your vehicle in other ways...

Categories

Erasing All The HomeLink® Channels

To erase the channels, follow this procedure:

Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes.

NOTE:

Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming additional buttons.

read more

 
Copyright © 2026 www.jewrangler.com