Jeep Wrangler: Yellow Warning Lights / Electronic Stability Control (ESC) OFF Warning Light — If Equipped

Jeep Wrangler. Electronic Stability Control (ESC) OFF Warning Light — If Equipped This warning light indicates the ESC is off.

Each time the ignition is turned to ON/RUN or ACC/ON/RUN, the ESC system will be on, even if it was turned off previously.

    Electronic Stability Control (ESC) Active Warning Light — If Equipped

    This warning light will indicate when the Electronic Stability Control system is Active. The ESC Indicator Light in the instrument cluster will come on when the ignition is placed in the ON/RUN or ACC/ON/RUN position, and when ESC is activated...

    Loose Fuel Filler Cap Warning Light — If Equipped

    This warning light will illuminate when the fuel filler cap is loose. Properly close the filler cap to disengage the light. If the light does not turn off, please see an authorized dealer...

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: Maintenance Plan — Diesel Fuel Up To B5 Biodiesel


    Refer to the maintenance plan for the required maintenance intervals. WARNING! You can be badly injured working on or around a motor vehicle. Do only service work for which you have the knowledge and the right equipment. If you have any doubt about your ability to perform a service job, take your vehicle to a competent mechanic...

    Jeep Wrangler 2018-2026 Owners Manual: EMISSIONS INSPECTION AND MAINTENANCE PROGRAMS


    In some localities, it may be a legal requirement to pass an inspection of your vehicle's emissions control system. Failure to pass could prevent vehicle registration. For states that require an Inspection and Maintenance (I/M), this check verifies the Malfunction Indicator Light (MIL) is functioning and is not on when the engine is running, and that the OBD II system is ready for testing...

    Categories

    Basic Voice Commands

    The basic Voice Commands below can be given at any point while using your Uconnect system. Push the VR button on the steering wheel. After the beep, say:

    “Cancel” to stop a current voice session. “Help” to hear a list of suggested Voice Commands. “Repeat” to listen to the system prompts again.

    read more

     
    Copyright © 2026 www.jewrangler.com