Jeep Wrangler: Yellow Warning Lights / Anti-Lock Brake System (ABS) Warning Light
This warning light monitors the
ABS.
The light will turn on when the ignition
is placed in the ON/RUN or ACC/ON/
RUN position and may stay on for as
long as four seconds.
If the ABS light remains on or turns on while driving, then the Anti-Lock portion of the brake system is not functioning and service is required as soon as possible. However, the conventional brake system will continue to operate normally, assuming the Brake Warning Light is not also on.
If the ABS light does not turn on when the ignition is placed in the ON/RUN or ACC/ON/ RUN position, have the brake system inspected by an authorized dealer.
Electronic Stability Control (ESC) Active Warning Light — If Equipped
This warning light will indicate
when
the Electronic Stability Control system
is Active. The ESC Indicator Light in
the instrument cluster will come on
when the ignition is placed in the ON/RUN or
ACC/ON/RUN position, and when ESC is activated...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Event Data Recorder (EDR)
This vehicle is equipped with an event data recorder (EDR). The main purpose of an EDR is to record, in certain crash or near crash-like situations, such as an air bag deployment or hitting a road obstacle, data that will assist in understanding how a vehicle’s systems performed...
Jeep Wrangler 2018-2026 Owners Manual: Adding Diesel Exhaust Fluid
The DEF gauge (located on the instrument cluster display) will display the level of DEF remaining in the tank. NOTE: Driving conditions (altitude, vehicle speed, load, etc.) will affect the amount of DEF that is used in your vehicle. DEF Fill Procedure NOTE: For the correct DEF fluid type...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Manual Seat Height Adjustment
- WHEEL AND TIRE TORQUE SPECIFICATIONS
- WARNING LIGHTS AND MESSAGES
- New on site
- Most important about car
Turn Signals. Lane Change Assist — If Equipped
Turn Signals
Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation.
NOTE:
If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb.
