Jeep Wrangler: Yellow Warning Lights / Cruise Control Fault Warning Light

Jeep Wrangler. Cruise Control Fault Warning Light This warning light will illuminate to indicate the Cruise Control System is not functioning properly and service is required. Contact an authorized dealer.

    Service Stop/Start System Warning Light — If Equipped

    This warning light will illuminate when the Stop/Start system is not functioning properly and service is required. Contact an authorized dealer for service...

    Sway Bar Fault Warning Light

    ..

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: Lap/Shoulder Belt Untwisting Procedure


    Use the following procedure to untwist a twisted lap/shoulder belt. Position the latch plate as close as possible to the anchor point. At about 6 to 12 inches (15 to 30 cm) above the latch plate, grab and twist the seat belt webbing 180 degrees to create a fold that begins immediately above the latch plate...

    Jeep Wrangler 2018-2026 Owners Manual: Cruise Control — If Equipped


    When engaged, the Cruise Control takes over accelerator operations at speeds greater than 20 mph (32 km/h). The Cruise Control buttons are located on the right side of the steering wheel. Cruise Control Buttons SET (+)/Accel CANC/Cancel SET (-)/Decel On/Off RES/Resume NOTE: In order to ensure proper operation, the Cruise Control system has been designed to shut down if multiple Cruise Control functions are operated at the same time...

    Categories

    To Unlock From The Driver or Passenger Side

    With a valid Passive Entry key fob within 5 ft (1.5 m) of the door handle, grab the handle to unlock the vehicle. Grabbing the driver’s door handle will unlock the driver door automatically. Grabbing the passenger door handle will unlock all doors and the swing gate automatically.

    Jeep Wrangler. To Unlock From The Driver or Passenger Side

    Grab The Door Handle To Unlock

    read more

     
    Copyright © 2026 www.jewrangler.com