Jeep Wrangler 2018-2025 Owners Manual / GETTING TO KNOW YOUR INSTRUMENT PANEL / WARNING LIGHTS AND MESSAGES / Yellow Warning Lights / Service Stop/Start System Warning Light — If Equipped

Jeep Wrangler: Yellow Warning Lights / Service Stop/Start System Warning Light — If Equipped

Jeep Wrangler. Service Stop/Start System Warning Light — If Equipped This warning light will illuminate when the Stop/Start system is not functioning properly and service is required. Contact an authorized dealer for service.

Service Forward Collision Warning (FCW) Light — If Equipped

Cruise Control Fault Warning Light

This warning light will illuminate to indicate the Cruise Control System is not functioning properly and service is required. Contact an authorized dealer...

Other information:

Jeep Wrangler 2018-2025 Owners Manual: Canadian/Gate Operator Programming

For programming transmitters in Canada/ United States that require the transmitter signals to “time-out” after several seconds of transmission. Canadian radio frequency laws require transmitter signals to time-out (or quit) after several seconds of transmission – which may not be long enough for HomeLink® to pick up the signal during programming...

Jeep Wrangler 2018-2025 Owners Manual: Cooling System Notes

NOTE: When the vehicle is stopped after a few miles/ kilometers of operation, you may observe vapor coming from the front of the engine compartment. This is normally a result of moisture from rain, snow, or high humidity accumulating on the radiator and being vaporized when the thermostat opens, allowing hot engine coolant (antifreeze) to enter the radiator...

Turn Signals. Lane Change Assist — If Equipped

Turn Signals

Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation.

NOTE:

If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb.