Jeep Wrangler 2018-2026 Owners Manual / GETTING TO KNOW YOUR INSTRUMENT PANEL / WARNING LIGHTS AND MESSAGES / Yellow Warning Lights / Service Forward Collision Warning (FCW) Light — If Equipped
Jeep Wrangler: Yellow Warning Lights / Service Forward Collision Warning (FCW) Light — If Equipped
This warning light will
illuminate to
indicate a fault in the Forward
Collision Warning System. Contact an
authorized dealer for service.
Service 4WD Warning Light — If Equipped
This
warning light will illuminate to
signal a fault with the 4WD system. If
the light stays on or comes on during
driving, it means that the 4WD system
is not functioning properly and that service is
required...
Service Stop/Start System Warning Light — If Equipped
This warning light will
illuminate when
the Stop/Start system is not
functioning properly and service is
required. Contact an authorized
dealer for service...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Possible Reasons The Engine Does Not Autostop
Prior to engine shut down, the system will check many safety and comfort conditions to see if they are fulfilled. Detailed information about the operation of the Stop/Start system may be viewed in the instrument cluster display Stop/ Start Screen...
Jeep Wrangler 2018-2026 Owners Manual: Operating Media Mode
..
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Manual Front Seat Recline Adjustment
- UCONNECT SETTINGS
- Auxiliary Switches — If Equipped
- New on site
- Most important about car
Erasing All The HomeLink® Channels
To erase the channels, follow this procedure:
Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes.NOTE:
Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming additional buttons.
Copyright © 2026 www.jewrangler.com