Jeep Wrangler: Yellow Warning Lights / Sway Bar Fault Warning Light

Jeep Wrangler. Sway Bar Fault Warning Light This light will illuminate when there is a fault in the sway bar disconnect system.

    Cruise Control Fault Warning Light

    This warning light will illuminate to indicate the Cruise Control System is not functioning properly and service is required. Contact an authorized dealer...

    Tire Pressure Monitoring System (TPMS) Warning Light

    The warning light switches on and a message is displayed to indicate that the tire pressure is lower than the recommended value and/or that slow pressure loss is occurring...

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: Axle Lock (Tru-Lok) Front And Rear — If Equipped


    The AXLE LOCK switch is located on the instrument panel (to the right of the steering column). Axle Lock Switch Panel This feature will only activate when the following conditions are met: Ignition in RUN position, vehicle in 4WD Low. Vehicle speed should be 10 mph (16 km/h) or less...

    Jeep Wrangler 2018-2026 Owners Manual: ENGINE BREAK-IN RECOMMENDATIONS — GASOLINE ENGINE (IF EQUIPPED)


    A long break-in period is not required for the engine and drivetrain (transmission and axle) in your vehicle. Drive moderately during the first 300 miles (500 km). After the initial 60 miles (100 km), speeds up to 50 or 55 mph (80 or 90 km/h) are desirable...

    Categories

    Basic Voice Commands

    The basic Voice Commands below can be given at any point while using your Uconnect system. Push the VR button on the steering wheel. After the beep, say:

    “Cancel” to stop a current voice session. “Help” to hear a list of suggested Voice Commands. “Repeat” to listen to the system prompts again.

    read more

     
    Copyright © 2026 www.jewrangler.com