Jeep Wrangler: WARNING LIGHTS AND MESSAGES / Red Warning Lights
The warning/indicator lights will illuminate in
the instrument panel together with a dedicated
message and/or acoustic signal when
applicable. These indications are indicative and
precautionary and as such must not be
considered as exhaustive and/or alternative to
the information contained in the Owner’s
Manual, which you are advised to read carefully
in all cases...
This warning light will
illuminate to
indicate a fault with the air bag, and
will turn on for four to eight seconds
as a bulb check when the ignition is
placed in the ON/RUN or ACC/ON/RUN
position...
Other information:
Use the following procedure to prepare your
vehicle for normal usage.
Bring the vehicle to a complete stop,
leaving it connected to the tow vehicle.
Firmly apply the parking brake.
Start the engine.
Press and hold the brake pedal.
Shift the transmission into NEUTRAL...
Fluid Level Check
Check the fluid level by removing the fill plug.
The fluid level should be between the bottom of
the fill hole and a point not more than 3/16 of
an inch (4.76 mm) below the bottom of the
hole.
Add fluid, if necessary, to maintain the proper
level...