Jeep Wrangler 2018-2026 Owners Manual / GETTING TO KNOW YOUR INSTRUMENT PANEL / WARNING LIGHTS AND MESSAGES / Red Warning Lights / Transmission Temperature Warning Light — If Equipped

Jeep Wrangler: Red Warning Lights / Transmission Temperature Warning Light — If Equipped

Jeep Wrangler. Transmission Temperature Warning Light — If Equipped This warning light will illuminate to warn of a high transmission fluid temperature. This may occur with strenuous usage such as trailer towing. If this light turns on, stop the vehicle and run the engine at idle or slightly faster, with the transmission in PARK (P) or NEUTRAL (N), until the light turns off. Once the light turns off, you may continue to drive normally.

WARNING!

If you continue operating the vehicle when the Transmission Temperature Warning Light is illuminated you could cause the fluid to boil over, come in contact with hot engine or exhaust components and cause a fire.

CAUTION!

Continuous driving with the Transmission Temperature Warning Light illuminated will eventually cause severe transmission damage or transmission failure.

Swing Gate Open Warning Light

Vehicle Security Warning Light — If Equipped

This light will flash at a fast rate for approximately 15 seconds when the Vehicle Security system is arming, and then will flash slowly until the vehicle is disarmed...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: Important Safety Precautions

Please pay close attention to the information in this section. It tells you how to use your restraint system properly, to keep you and your passengers as safe as possible. Here are some simple steps you can take to minimize the risk of harm from a deploying air bag: Children 12 years old and under should always ride buckled up in the rear seat of a vehicle with a rear seat...

Jeep Wrangler 2018-2026 Owners Manual: Instrument Cluster Display Menu Items

NOTE: Depending on the vehicle’s options, feature settings may vary. Speedometer Push and release the up or down arrow button until the speedometer menu icon is displayed in the instrument cluster display. Push and release the OK button to toggle between MPH and km/h...