Jeep Wrangler: Red Warning Lights / Door Open Warning Light

Jeep Wrangler. Door Open Warning Light This indicator will illuminate when a door is ajar/open and not fully closed.

NOTE:

If the vehicle is moving, there will also be a single chime.

    Battery Charge Warning Light

    This warning light will illuminate when the battery is not charging properly. If it stays on while the engine is running, there may be a malfunction with the charging system...

    Electric Power Steering (EPS) Fault Warning Light

    This warning light will turn on when there's a fault with the EPS system. WARNING! Continued operation with reduced assist could pose a safety risk to yourself and others...

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: Enhanced Accident Response System


    In the event of an impact, if the communication network remains intact, and the power remains intact, depending on the nature of the event, the Occupant Restraint Controller (ORC) will determine whether to have the Enhanced Accident Response System perform the following functions: Cut off fuel to the engine (if equipped)...

    Jeep Wrangler 2018-2026 Owners Manual: Brake Warning Light


    This warning light monitors various brake functions, including brake fluid level and parking brake application. If the brake light turns on it may indicate that the parking brake is applied, that the brake fluid level is low, or that there is a problem with the Anti-Lock Brake System reservoir...

    Categories

    Erasing All The HomeLink® Channels

    To erase the channels, follow this procedure:

    Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes.

    NOTE:

    Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming additional buttons.

    read more

     
    Copyright © 2026 www.jewrangler.com