Jeep Wrangler 2018-2024 Owners Manual / GETTING TO KNOW YOUR INSTRUMENT PANEL / WARNING LIGHTS AND MESSAGES / Red Warning Lights / Electric Power Steering (EPS) Fault Warning Light
Jeep Wrangler: Red Warning Lights / Electric Power Steering (EPS) Fault Warning Light
This warning light will turn on
when
there's a fault with the EPS system.
WARNING!
Continued operation with reduced assist could pose a safety risk to yourself and others. Service should be obtained as soon as possible.
Electronic Throttle Control (ETC) Warning Light
This warning light will
illuminate to
indicate a problem with the ETC
system. If a problem is detected while
the vehicle is running, the light will
either stay on or flash depending on the nature
of the problem...
Other information:
Jeep Wrangler 2018-2024 Owners Manual: Operating Media Mode
..
Jeep Wrangler 2018-2024 Owners Manual: FCW Braking Status And Sensitivity
The FCW Sensitivity and Active Braking status are programmable through the Uconnect system. Far When the sensitivity of FCW is set to the “Far” setting and the system status is “Only Warning”, this allows the system to warn the driver of a possible more distant collision with the vehicle in front using audible/visual warnings...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Automatic High Beam Headlamp Control — If Equipped, Flash-To-Pass
- Display Warnings And Maintenance
- Jack Location
- New on site
- Most important about car
Turn Signals. Lane Change Assist — If Equipped
Turn Signals
Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation.
NOTE:
If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb.
Copyright © 2024 www.jewrangler.com