Jeep Wrangler: OCCUPANT RESTRAINT SYSTEMS / Air Bag System Components

NOTE:

The Occupant Restraint Controller (ORC) monitors the internal circuits and interconnecting wiring associated with electrical Air Bag System Components listed below:

  • Occupant Restraint Controller (ORC)
  • Air Bag Warning Light Jeep Wrangler. Air Bag System Components
  • Steering Wheel and Column
  • Instrument Panel
  • Knee Impact Bolsters
  • Driver and Front Passenger Air Bags
  • Seat Belt Buckle Switch
  • Supplemental Side Air Bags
  • Front and Side Impact Sensors
  • Seat Belt Pretensioners
  • Seat Track Position Sensors
  • Occupant Classification System

    Side Impacts

    The Side Air Bags are designed to activate in certain side impacts. The Occupant Restraint Controller (ORC) determines whether the deployment of the Side Air Bags in a particular impact event is appropriate, based on the severity and type of collision...

    If A Deployment Occurs

    The front air bags are designed to deflate immediately after deployment. NOTE: Front and/or side air bags will not deploy in all collisions. This does not mean something is wrong with the air bag system...

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: Installing The Soft Top


    If currently installed, remove the hard top. Install the door rails, starting with the front, followed by the rear on each side. For instructions and appropriate torque specifications for the door rail Torx screws. Install the rear retainers on each side of the rear of the vehicle using the provided #50 Torx head driver and ratchet...

    Jeep Wrangler 2018-2026 Owners Manual: Heated Seats — If Equipped


    The heated seat control buttons are located on the center instrument panel below the touchscreen and also in the Climate Control touchscreen menu. Heated Seat Buttons Push the heated seat button once to turn the HI setting on. Push the heated seat button a second time to turn the MED setting on...

    Categories

    Basic Voice Commands

    The basic Voice Commands below can be given at any point while using your Uconnect system. Push the VR button on the steering wheel. After the beep, say:

    “Cancel” to stop a current voice session. “Help” to hear a list of suggested Voice Commands. “Repeat” to listen to the system prompts again.

    read more

     
    Copyright © 2026 www.jewrangler.com