Jeep Wrangler 2018-2026 Owners Manual / GETTING TO KNOW YOUR VEHICLE / REMOTE START — IF EQUIPPED (GASOLINE)

Jeep Wrangler: GETTING TO KNOW YOUR VEHICLE / REMOTE START — IF EQUIPPED (GASOLINE)

Jeep Wrangler. REMOTE START — IF EQUIPPED (GASOLINE) This system uses the key fob to start the engine conveniently from outside the vehicle while still maintaining security. The system has a range of 328 ft (100 m).

Remote Start is used to defrost windows in cold weather, and to reach a comfortable climate in all ambient conditions before the driver enters the vehicle.

NOTE:

  • The vehicle must be equipped with an automatic transmission to be equipped with Remote Start.
  • Obstructions between the vehicle and key fob may reduce this range.

WARNING!

  • Do not start or run an engine in a closed garage or confined area. Exhaust gas contains Carbon Monoxide (CO) which is odorless and colorless. Carbon Monoxide is poisonous and can cause serious injury or death when inhaled.
  • Keep key fobs away from children. Operation of the Remote Start system, windows, door locks or other controls could cause serious injury or death.

IGNITION SWITCH

KEYLESS ENTER-N-GO IGNITION If applicable, refer to the “Hybrid Supplement” for additional information. This feature allows the driver to operate the ignition switch with the push of a button as long as the key fob is in the passenger compartment...

How To Use Remote Start

If applicable, refer to the “Hybrid Supplement” for additional information. Push and release the Remote Start button on the key fob twice within five seconds...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: Vehicle Finder


Description The Vehicle Finder feature of the Uconnect App allows you to find the location of your stationary vehicle. You can also sound the horn and flash the lights to make finding your vehicle even easier. How It Works Use the Uconnect App to find the location of your vehicle...

Jeep Wrangler 2018-2026 Owners Manual: Automatic High Beam Headlamp Control — If Equipped, Flash-To-Pass


Automatic High Beam Headlamp Control The Automatic High Beam Headlamp Control system provides increased forward lighting at night by automatically controlling the high beams through the use of a camera mounted on the vehicle’s header. This camera detects vehicle specific light and automatically switches from high beams to low beams until the approaching vehicle is out of view...

Categories

Basic Voice Commands

The basic Voice Commands below can be given at any point while using your Uconnect system. Push the VR button on the steering wheel. After the beep, say:

“Cancel” to stop a current voice session. “Help” to hear a list of suggested Voice Commands. “Repeat” to listen to the system prompts again.

read more

 
Copyright © 2026 www.jewrangler.com