Jeep Wrangler: Carpet Removal / Cargo Carpet (Four Door Models) With Gap Hider
- Remove the grommets under the rear seat
(one left and one right).
- Pull the carpet out to the front and open the
carpet split around the seat belt attachment
and under the center seat bracket.

Under Rear Seat
- Carpet Split
- Grommets
- Rear Carpet
- When reinstalling carpet please perform
these steps in reverse order making sure
that the carpet is tucked under the scuffs,
B-pillar, console, and refasten grommets.
Remove the grommets under the rear seat
(one left and one right).
Pull the carpet out to the rear and open the
carpet split around the seat belt
attachment...
Remove the side grommet (one left and
one right).
Pull the carpet out starting on the top
flange, then all around the perimeter and
open the carpet split around the seat belt
attachment...
Other information:
The lower anchorages are round
bars
that are found at the rear of the seat
cushion where it meets the seatback.
They are just visible when you lean
into the rear seat to install the child restraint.
You will easily feel them if you run your finger
along the gap between the seatback and seat
cushion...
The transmission must be in PARK or
NEUTRAL.
Press and hold the brake pedal while
pushing the ENGINE START/STOP button
once.
The system takes over and attempts to start
the vehicle. If the vehicle fails to start, the
starter will disengage automatically after
10 seconds...