Jeep Wrangler: Carpet Removal / Side Carpet (Four Door Models)
- Remove the side grommet (one left and
one right).
- Pull the carpet out starting on the top
flange, then all around the perimeter and
open the carpet split around the seat belt
attachment.

Inside Sidewall
- Top Flange
- Grommet
- Side Carpet
- When reinstalling carpet please perform
these steps in reverse order making sure
that the carpet is tucked under the scuffs,
B-pillar, console, and refasten grommets.
Remove the grommets under the rear seat
(one left and one right).
Pull the carpet out to the front and open the
carpet split around the seat belt attachment
and under the center seat bracket...
Remove the side grommet and then the
lower one (left and right).
Pull the carpet out starting on the top
flange, then all around the perimeter and
open the carpet split around the seat belt
attachment...
Other information:
When off-road driving, shift into 4WD Low for
additional traction and control on slippery or
difficult terrain, ascending or descending steep
hills, and to increase low speed pulling power.
This range should be limited to extreme
situations such as deep snow, mud, steep
inclines, or sand where additional low speed
pulling power is needed...
The engine block heater is a resistance heater
installed in the water jacket of the engine. It
requires a 110–115 Volt AC electrical outlet
with a grounded, three-wire extension cord. Its
use is recommended for environments that
routinely fall below -10°F (-23°C)...