Jeep Wrangler: Carpet Removal / Side Carpet (Two Door Models)
Remove the side grommet and then the lower one (left and right).
Pull the carpet out starting on the top flange, then all around the perimeter and open the carpet split around the seat belt attachment.
When reinstalling carpet please perform these steps in reverse order making sure that the carpet is tucked under the scuffs, B-pillar, console, and refasten grommets.
Side Carpet (Four Door Models)
Remove the side grommet (one left and
one right).
Pull the carpet out starting on the top
flange, then all around the perimeter and
open the carpet split around the seat belt
attachment...
Seats And Fabric Parts
Use Mopar® Total Clean to clean fabric
upholstery and carpeting.
WARNING!
Do not use volatile solvents for cleaning
purposes. Many are potentially flammable,
and if used in closed areas they may cause
respiratory harm...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: PARKING BRAKE
Before exiting the vehicle, make sure that the parking brake is fully applied. Also, be certain to leave an automatic transmission in PARK, or manual transmission in REVERSE or FIRST gear. The parking brake lever is located in the center console...
Jeep Wrangler 2018-2026 Owners Manual: Care Of Fabric Top Windows
Your vehicle's fabric top has pliable plastic windows which can be scratched unless special care is taken by following these directions: Never use a dry cloth to remove dust. Instead, use a microfiber towel or soft cotton cloth moistened with cold or warm, clean water, and wipe across the window, not up and down...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- SiriusXM® Satellite Radio Mode — If Equipped
- Draining Fuel/Water Separator Filter — Diesel Engine
- Manual Seat Height Adjustment
- New on site
- Most important about car
Automatic Headlights — If Equipped, Lights-On Reminder
Automatic Headlights
This system automatically turns the headlights on or off according to ambient light levels. To turn the system on, rotate the headlight switch clockwise to the last detent for automatic headlight operation. When the system is on, the headlight time delay feature is also on. This means the headlights will stay on for up to 90 seconds after you place the ignition into the OFF position. To turn the automatic system off, move the headlight switch out of the AUTO position.
