Jeep Wrangler 2018-2026 Owners Manual / GETTING TO KNOW YOUR VEHICLE / REMOTE START — IF EQUIPPED (GASOLINE) / Remote Start Cancel Message
Jeep Wrangler: REMOTE START — IF EQUIPPED (GASOLINE) / Remote Start Cancel Message
The following messages will display in the instrument cluster if the vehicle fails to Remote Start or exits Remote Start prematurely:
- Remote Start Cancelled — Door Open
- Remote Start Cancelled — Hood Open
- Remote Start Cancelled — Fuel Low
- Remote Start Cancelled — Swing Gate Open
- Remote Start Cancelled — Time Expired
- Remote Start Disabled — Start Vehicle To Reset
The message will stay active until the ignition is placed in the ON/RUN position.
Remote Start Comfort Systems — If Equipped
When Remote Start is activated, the front and
rear defrost will automatically turn on in cold
weather. The heated steering wheel and driver
heated seat feature will turn on if programmed in
the comfort menu screen within Uconnect
Settings...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Engine Coolant Level — 2.0L
WARNING! Do not open hot engine cooling system. Never add engine coolant (antifreeze) when the engine is overheated. Do not loosen or remove the cap to cool an overheated engine. Heat causes pressure to build up in the cooling system. To prevent scalding or injury, do not remove the pressure cap while the system is hot or under pressure...
Jeep Wrangler 2018-2026 Owners Manual: Turning FCW On Or Off
The FCW button is located in the Uconnect display in the control settings. To turn the FCW system on, press the forward collision button once. To turn the FCW system off, press the forward collision button once. NOTE: When the FCW is “on”, this allows the system to warn the driver of a possible collision with the vehicle in front...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Jack Location
- Auxiliary Switches — If Equipped
- Programming HomeLink® To A Garage Door Opener
- New on site
- Most important about car
Manual Front Seat Forward/Rearward Adjustment
The seat can be adjusted forward or rearward by using a bar located by the front of the seat cushion, near the floor. While sitting in the seat, lift up on the bar located under the seat cushion and move the seat forward or rearward. Release the bar once you have reached the desired position. Then, using body pressure, move forward and rearward on the seat to be sure that the seat adjusters have latched.
Adjustment Bar Location
Copyright © 2026 www.jewrangler.com