Jeep Wrangler: GETTING TO KNOW YOUR VEHICLE / REAR SWING GATE

Closing The Hood

If applicable, refer to the “Hybrid Supplement” for additional information. To close the hood, remove the support rod from the slot and replace it on the hood panel retaining clip...

Opening the swing gate

  The rear swing gate can be unlocked by using one of the following methods: Mechanical key (with mechanical lock — if equipped) Remote Keyless Entry key fob (if equipped) Power door unlock switch on the front doors (if equipped) Passive Entry swing gate handle (if equipped) To open the swing gate, pull on the handle...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: ENGINE BLOCK HEATER — IF EQUIPPED


The engine block heater warms the engine, and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded, three-wire extension cord. Diesel Engine Block Heater Cord Location The engine block heater cord is found under the hood bundled up next to the Power Distribution Center (PDC)...

Jeep Wrangler 2018-2026 Owners Manual: Removing The Rear Seat


Push down on the release bar on each side, and pull the seat out and away from the lower bracket. Release Bar Location Remove the seat from the vehicle. To reinstall the rear seat, just reverse these steps. NOTE: Do not drive the vehicle without reattaching the rear seat latches...

Categories

Manual Front Seat Forward/Rearward Adjustment

The seat can be adjusted forward or rearward by using a bar located by the front of the seat cushion, near the floor. While sitting in the seat, lift up on the bar located under the seat cushion and move the seat forward or rearward. Release the bar once you have reached the desired position. Then, using body pressure, move forward and rearward on the seat to be sure that the seat adjusters have latched.

Jeep Wrangler. Manual Front Seat Forward/Rearward Adjustment

Adjustment Bar Location

read more

 
Copyright © 2026 www.jewrangler.com