Jeep Wrangler: REAR SWING GATE / Cargo Area Features

Trail Rail Cargo Organizer — If Equipped

If your vehicle is equipped with the Trail Rail system, a rail will be found built into the floor on either side of the cargo area. Each rail contains an adjustable anchor loop that can be used to secure cargo. The position of the adjustable anchor loop can be adjusted by sliding the loop along the rail.

To adjust the anchor loop, push down on the center button while sliding the loop along the rail to the desired position. Release the button and move the loop slightly to the next fixed position in the notches of the rail.

Jeep Wrangler. Cargo Area Features

Adjustable Anchor Loop

 

Lift the loop to use.

Jeep Wrangler. Cargo Area Features

Lift Adjustable Anchor Loop

    Opening the swing gate

      The rear swing gate can be unlocked by using one of the following methods: Mechanical key (with mechanical lock — if equipped) Remote Keyless Entry key fob (if equipped) Power door unlock switch on the front doors (if equipped) Passive Entry swing gate handle (if equipped) To open the swing gate, pull on the handle...

    ROOF LUGGAGE RACK — IF EQUIPPED

    NOTE: Roof rack applications are for Hard Top models ONLY. The load carried on the roof, when equipped with a luggage rack, must not exceed 100 lb (45 kg), this includes the weight of the crossbars, and it should be uniformly distributed over the cargo area...

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: BRAKE SYSTEM


    Your vehicle is equipped with dual hydraulic brake systems. If either of the two hydraulic systems loses normal capability, the remaining system will still function. However, there will be some loss of overall braking effectiveness. You may notice increased pedal travel during application, greater pedal force required to slow or stop, and potential activation of the Brake Warning Light...

    Jeep Wrangler 2018-2026 Owners Manual: If Engine Fails To Start


    If the engine fails to start after you have followed the “Normal Starting” or “Extreme Cold Weather” procedure, it may be flooded. Push the accelerator pedal all the way to the floor and hold it there. Crank the engine for no more than 15 seconds...

    Categories

    Turn Signals. Lane Change Assist — If Equipped

    Turn Signals

    Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation.

    NOTE:

    If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb.

    read more

     
    Copyright © 2026 www.jewrangler.com