Jeep Wrangler: SERVICING AND MAINTENANCE / ENGINE COMPARTMENT

Additional Maintenance — B6 To B20 Biodiesel

NOTE: Under no circumstances should oil change intervals exceed 8,000 miles (12,875 km) or six months, whichever comes first when using biodiesel blends greater than 5% (B5)...

2.0L Gasoline Engine

..

Other information:

Jeep Wrangler 2018-2026 Owners Manual: Coolant Checks


Check the engine, battery (if equipped), intercooler (if equipped), and Motor Generator Unit (MGU) (if equipped) coolant (antifreeze) protection every 12 months (before the onset of freezing weather, where applicable). If the engine, battery (if equipped), intercooler (if equipped), and MGU (if equipped) coolant is dirty or rusty in appearance, the system should be drained, flushed and refilled with fresh OAT coolant (conforming to MS...

Jeep Wrangler 2018-2026 Owners Manual: Rear Head Restraints — Two Door Models


The rear seat is equipped with non-adjustable, but foldable head restraints. To fold the outboard head restraint, pull on the release strap located on the upper outboard side of each rear seat. Rear Head Restraint Folding Strap Location Rear Head Restraints Folded To return the head restraint to its upward position, lift up on the head restraint until it locks into place...

Categories

Erasing All The HomeLink® Channels

To erase the channels, follow this procedure:

Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes.

NOTE:

Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming additional buttons.

read more

 
Copyright © 2026 www.jewrangler.com