Jeep Wrangler: ENGINE COMPARTMENT / 3.6L Gasoline Engine

Jeep Wrangler. 3.6L Gasoline Engine

  1. Power Distribution Center (Fuses)
  2. Battery
  3. Engine Oil Dipstick
  4. Engine Oil Fill
  5. Engine Coolant Pressure Cap
  6. Brake Fluid Reservoir Cap
  7. Power Pack Unit Pressure Cap — If Equipped
  8. Washer Fluid Reservoir Cap
  9. Motor Generator Unit Coolant Pressure Cap— If Equipped
  10. Power Steering Reservoir Cap
  11. Engine Air Cleaner Filter

    2.0L Gasoline Engine

    ..

    3.0L Diesel Engine

    ..

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: Extreme Cold Weather


    The engine block heater is a resistance heater installed in the water jacket of the engine. It requires a 110–115 Volt AC electrical outlet with a grounded, three-wire extension cord. Its use is recommended for environments that routinely fall below -10°F (-23°C)...

    Jeep Wrangler 2018-2026 Owners Manual: Auxiliary Switches — If Equipped


    Four auxiliary switches located in the lower switch bank of the instrument panel can be used to power various electrical devices. You have the ability to configure the functionality of the auxiliary switches via the Uconnect Settings. All switches can be configured as follows: Switch type operation: Latching or Momentary Power source: Battery or Ignition Ability to hold last state across key cycles: On or Off Auxiliary Switches NOTE: Holding last state conditions are met when switch type is set to latching and power source is set to ignition...

    Categories

    To Unlock From The Driver or Passenger Side

    With a valid Passive Entry key fob within 5 ft (1.5 m) of the door handle, grab the handle to unlock the vehicle. Grabbing the driver’s door handle will unlock the driver door automatically. Grabbing the passenger door handle will unlock all doors and the swing gate automatically.

    Jeep Wrangler. To Unlock From The Driver or Passenger Side

    Grab The Door Handle To Unlock

    read more

     
    Copyright © 2026 www.jewrangler.com