Jeep Wrangler: Carpet Removal / Rear Carpet (Two Door Models)
- Remove the rear seats.
- Remove the sides grommets (one left and
one right). First the grommet from the side
carpet and then the rear carpet.

Side Carpet
- Remove the grommets under the front seat
(one left and one right).
- Then pull the carpet out to the rear and
open the carpet split around the front seats
brackets.

Pull Carpet To The Rear
- Carpet Split
- Rear Carpet
- When reinstalling carpet please perform
these steps in reverse order making sure
that the carpet is tucked under the scuffs,
B-pillar, console, and refasten grommets.
Remove the grommets under the front seat
(one left and one right).
Then pull the carpet out, to the rear and
open the carpet split around the front seats
brackets...
Remove the grommets under the rear seat
(one left and one right).
Pull the carpet out to the rear and open the
carpet split around the seat belt
attachment...
Other information:
The BSM system uses two radar sensors,
located inside the taillights, to detect highway
licensable vehicles (automobiles, trucks,
motorcycles, etc.) that enter the blind spot
zones from the rear/front/side of the vehicle.
Rear Detection Zones
When the vehicle is started, the BSM Warning
Light will momentarily illuminate in both outside
rearview mirrors to let the driver know that the
system is operational...
Disconnect the negative (-) end of the
jumper cable from the engine ground of
the vehicle with the discharged battery.
Disconnect the opposite end of the negative
(-) jumper cable from the negative (-) post of
the booster battery.
Disconnect the positive (+) end of the
jumper cable from the positive (+) post of
the booster battery...