Jeep Wrangler: IN CASE OF EMERGENCY / HAZARD WARNING FLASHERS
The Hazard Warning Flashers switch is located
on the instrument panel below the climate
controls.

Hazard Warning Flashers Switch
Push the switch to turn on the Hazard Warning
Flashers. When the switch is activated, all
directional turn signals will flash on and off to
warn oncoming traffic of an emergency. Push
the switch a second time to turn off the Hazard
Warning Flashers.
This is an emergency warning system and it
should not be used when the vehicle is in
motion. Use it when your vehicle is disabled and
it is creating a safety hazard for other motorists.
When you must leave the vehicle to seek
assistance, the Hazard Warning Flashers will
continue to operate even though the ignition is
placed in the OFF position.
NOTE:
With extended use the Hazard Warning
Flashers may wear down your battery.
Assist And SOS Buttons
Assist Button
SOS Button
If equipped, the overhead console contains an
ASSIST and an SOS button.
WARNING!
ALWAYS obey traffic laws and pay attention to
the road...
Other information:
When off-road driving, shift into 4WD Low for
additional traction and control on slippery or
difficult terrain, ascending or descending steep
hills, and to increase low speed pulling power.
This range should be limited to extreme
situations such as deep snow, mud, steep
inclines, or sand where additional low speed
pulling power is needed...
Place the gear selector in PARK, then push
and release the ENGINE START/STOP button.
The ignition will return to the OFF mode.
If the gear selector is not in PARK (with
vehicle stopped) and the ENGINE START/
STOP button is pushed once, the
transmission will automatically select PARK
and the engine will turn off while the ignition
will remain in the ACC mode (NOT the OFF
mode)...