Jeep Wrangler: IN CASE OF EMERGENCY / ASSIST AND SOS SYSTEM — IF EQUIPPED

Assist And SOS Buttons
- Assist Button
- SOS Button
If equipped, the overhead console contains an
ASSIST and an SOS button.
WARNING!
ALWAYS obey traffic laws and pay attention to
the road. ALWAYS drive safely with your hands
on the steering wheel. You have full
responsibility and assume all risks related to
the use of the features and applications in
this vehicle. Only use the features and
applications when it is safe to do so. Failure
to do so may result in an accident involving
serious injury or death.
NOTE:
- Your vehicle may be transmitting data as
authorized by the subscriber.
- The ASSIST and SOS buttons will only function
if you are connected to an operable LTE
(voice/data) or 4G (data) network, which
comes as a built-in function. Other Uconnect
services will only be operable if your SiriusXM
Guardian™ service is active and you are
connected to an operable LTE (voice/data) or
4G (data) network.
The Hazard Warning Flashers switch is located
on the instrument panel below the climate
controls.
Hazard Warning Flashers Switch
Push the switch to turn on the Hazard Warning
Flashers...
The ASSIST Button is used to automatically
connect you to any one of the following support
centers:
Roadside Assistance – If you get a flat tire, or
need a tow, just push the ASSIST button and
you’ll be connected to someone who can
help...
Other information:
When the gear selector is in NEUTRAL, the
engine will start when the clutch pedal is
pressed (does not require complete/full pedal
press). The vehicle will go into STOP/START
SYSTEM NOT READY mode until the vehicle
speed is greater than 5 mph (8 km/h)...
Remove the rear seats.
Remove the sides grommets (one left and
one right). First the grommet from the side
carpet and then the rear carpet.
Side Carpet
Remove the grommets under the front seat
(one left and one right).
Then pull the carpet out to the rear and
open the carpet split around the front seats
brackets...