Jeep Wrangler 2018-2026 Owners Manual / STARTING AND OPERATING / STARTING THE ENGINE — GASOLINE ENGINE (IF EQUIPPED)

Jeep Wrangler: STARTING AND OPERATING / STARTING THE ENGINE — GASOLINE ENGINE (IF EQUIPPED)

Before starting your vehicle, adjust your seat, adjust both inside and outside mirrors, and fasten your seat belts.

WARNING!

  • When exiting the vehicle, always remove the key fob from the ignition and lock your vehicle.
  • Never leave children alone in a vehicle, or with access to an unlocked vehicle.
  • Allowing children to be in a vehicle unattended is dangerous for a number of reasons. A child or others could be seriously or fatally injured. Children should be warned not to touch the parking brake, brake pedal or the gear selector.
  • Do not leave the key fob in or near the vehicle, or in a location accessible to children. A child could operate power windows, other controls, or move the vehicle.
  • Do not leave children or animals inside parked vehicles in hot weather. Interior heat build-up may cause serious injury or death.

STARTING AND OPERATING

..

Manual Transmission — If Equipped

Apply the parking brake, place the gear selector in NEUTRAL, and press the clutch pedal before starting the vehicle. This vehicle is equipped with a clutch interlocking ignition system...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: ENGINE BREAK-IN RECOMMENDATIONS — GASOLINE ENGINE (IF EQUIPPED)


A long break-in period is not required for the engine and drivetrain (transmission and axle) in your vehicle. Drive moderately during the first 300 miles (500 km). After the initial 60 miles (100 km), speeds up to 50 or 55 mph (80 or 90 km/h) are desirable...

Jeep Wrangler 2018-2026 Owners Manual: Care Of Fabric Top Windows


Your vehicle's fabric top has pliable plastic windows which can be scratched unless special care is taken by following these directions: Never use a dry cloth to remove dust. Instead, use a microfiber towel or soft cotton cloth moistened with cold or warm, clean water, and wipe across the window, not up and down...

Categories

Turn Signals. Lane Change Assist — If Equipped

Turn Signals

Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation.

NOTE:

If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb.

read more

 
Copyright © 2026 www.jewrangler.com