Jeep Wrangler: STARTING THE ENGINE — GASOLINE ENGINE (IF EQUIPPED) / Normal Starting
Start the vehicle with the gear selector in the
PARK position (vehicle can also be started in
NEUTRAL). Apply the brake before shifting to
any driving range...
The transmission must be in PARK or
NEUTRAL.
Press and hold the brake pedal while
pushing the ENGINE START/STOP button
once.
The system takes over and attempts to start
the vehicle...
Other information:
This warning light will
illuminate to
indicate a fault with the air bag, and
will turn on for four to eight seconds
as a bulb check when the ignition is
placed in the ON/RUN or ACC/ON/RUN
position. This light will illuminate with a single
chime when a fault with the air bag has been
detected, it will stay on until the fault is cleared...
Remove the rear window and quarter panel
windows.
From the Sunrider® position,
remove straps if previously secured and
move to the rear of the vehicle.
Locate the Sunrider® latch beneath the #6
Bow of the soft top on the left side.
Step Three
Pull the latch to release the top, and allow
the soft top to slide rearward freely in the
guide tracks to the stowed position...