Jeep Wrangler: STARTING THE ENGINE — GASOLINE ENGINE (IF EQUIPPED) / After Starting
The idle speed is controlled automatically and
will decrease as the engine warms up.
If the engine fails to start after you have
followed the “Normal Starting” or “Extreme Cold
Weather” procedure, it may be flooded. Push
the accelerator pedal all the way to the floor and
hold it there...
Before starting your vehicle, adjust your seat,
both inside and outside mirrors, and fasten your
seat belts.
The starter is allowed to crank for up to
30-second intervals...
Other information:
There are two retention straps located on
the back of the rear seat and two
corresponding wire loops located on the
back of each B-pillar. Open the
hook-and-loop fastener on the strap and
thread through the wire loop. Fold the
hook-and-loop fastener over to keep the
seat in the folded position...
The driver door power and the passenger door
power window switches have an Auto-Down
feature. Push the window switch down to the
second detent and release, and the window will
go down automatically.
To stop the window from going all the way down
during the Auto-Down operation, pull up on the
switch briefly...