Jeep Wrangler: Automatic Climate Control Descriptions And Functions / AUTO Button
Set your desired temperature and
press AUTO. AUTO will achieve and
maintain your desired temperature by
automatically adjusting the blower
speed and air distribution. AUTO mode is highly
recommended for efficiency. You can press and
release this button on the touchscreen, or push
the button on the faceplate, to turn AUTO on.
The AUTO indicator illuminates when AUTO is
on. Toggling this function will cause the system
to switch between manual mode and automatic
mode.
Recirculation Button
Press and release this button on
the
touchscreen, or push the button on
the faceplate, to change the system
between recirculation mode and
outside air mode...
Front Defrost Button
Press and release this button on
the
touchscreen, or push and release the
button on the faceplate, to change
the current airflow setting to Defrost
mode...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Locating The LATCH Anchorages
The lower anchorages are round bars that are found at the rear of the seat cushion where it meets the seatback. They are just visible when you lean into the rear seat to install the child restraint. You will easily feel them if you run your finger along the gap between the seatback and seat cushion...
Jeep Wrangler 2018-2026 Owners Manual: ENGINE BLOCK HEATER — IF EQUIPPED
The engine block heater warms the engine, and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded, three-wire extension cord. Diesel Engine Block Heater Cord Location The engine block heater cord is found under the hood bundled up next to the Power Distribution Center (PDC)...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- SERVICING AND MAINTENANCE
- Programming HomeLink® To A Garage Door Opener
- WARNING LIGHTS AND MESSAGES
- New on site
- Most important about car
Bi-Level Mode
Air comes from the instrument
panel
outlets and floor outlets. A slight
amount of air is directed through the
defrost and side window demister
outlets.
NOTE:
Bi-Level mode is designed under comfort conditions to provide cooler air out of the panel outlets and warmer air from the floor outlets.
