Jeep Wrangler: Automatic Climate Control Descriptions And Functions / Recirculation Button

Jeep Wrangler. Recirculation Button Press and release this button on the touchscreen, or push the button on the faceplate, to change the system between recirculation mode and outside air mode. The Recirculation indicator and the A/C indicator illuminate when the Recirculation button is pressed. Recirculation can be used when outside conditions, such as smoke, odors, dust, or high humidity are present. Recirculation can be used in all modes. Recirculation may be unavailable (button on the touchscreen greyed out) if conditions exist that could create fogging on the inside of the windshield. The A/C can be deselected manually without disturbing the mode control selection. Continuous use of the Recirculation mode may make the inside air stuffy and window fogging may occur. Extended use of this mode is not recommended.

In cold weather, use of Recirculation mode may lead to excessive window fogging.

    A/C Button

    Press and release this button on the touchscreen, or push the button on the faceplate to change the current setting. The A/C indicator illuminates when A/C is on...

    AUTO Button

    Set your desired temperature and press AUTO. AUTO will achieve and maintain your desired temperature by automatically adjusting the blower speed and air distribution...

    Other information:

    Jeep Wrangler 2018-2025 Owners Manual: Cold Weather Precautions


    Operation in ambient temperature below 32°F (0°C) may require special considerations. The following charts suggest these options: Fuel Operating Range NOTE: Use “Ultra Low Sulfur Diesel Fuels (ULSD)” ONLY. Fuel Operating Range Chart *Number 1 ULSD Fuel should only be used where extended arctic conditions 0°F (-18°C) exist...

    Jeep Wrangler 2018-2025 Owners Manual: To Arm The System


    Follow these steps to arm the Vehicle Security system: Make sure the vehicle’s ignition is placed in the OFF position. Perform one of the following methods to lock the vehicle: Push lock on the interior power door lock switch with the driver and/or passenger door open...

    Categories

    Basic Voice Commands

    The basic Voice Commands below can be given at any point while using your Uconnect system. Push the VR button on the steering wheel. After the beep, say:

    “Cancel” to stop a current voice session. “Help” to hear a list of suggested Voice Commands. “Repeat” to listen to the system prompts again.

    read more

     
    Copyright © 2025 www.jewrangler.com