Jeep Wrangler 2018-2026 Owners Manual / GETTING TO KNOW YOUR VEHICLE / CLIMATE CONTROLS / Automatic Climate Control Descriptions And Functions

Jeep Wrangler: CLIMATE CONTROLS / Automatic Climate Control Descriptions And Functions

Jeep Wrangler. Automatic Climate Control Descriptions And Functions

Uconnect 4 With 7-inch Display Automatic Climate Controls

Jeep Wrangler. Automatic Climate Control Descriptions And Functions

Uconnect 4C/4C NAV With 8.4-inch Display Automatic Climate Controls

CLIMATE CONTROLS

The Climate Control system allows you to regulate the temperature, air flow, and direction of air circulating throughout the vehicle. The controls are located on the touchscreen (if equipped) and on the instrument panel below the radio...

MAX A/C Button

Press and release the MAX A/C button on the touchscreen to change the current setting to the coldest output of air. The MAX A/C indicator illuminates when MAX A/C is on...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: Turn Signals. Lane Change Assist — If Equipped


Turn Signals Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation. NOTE: If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb...

Jeep Wrangler 2018-2026 Owners Manual: Bulk Fuel Storage — Diesel Fuel


If you store quantities of fuel, good maintenance of the stored fuel is also essential. Fuel contaminated with water will promote the growth of “microbes.” These microbes form “slime” that will clog the fuel filtration system and lines. Drain condensation from the supply tank and change the line filter on a regular basis...

Categories

Erasing All The HomeLink® Channels

To erase the channels, follow this procedure:

Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes.

NOTE:

Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming additional buttons.

read more

 
Copyright © 2026 www.jewrangler.com