Jeep Wrangler 2018-2026 Owners Manual / GETTING TO KNOW YOUR VEHICLE / CLIMATE CONTROLS / Automatic Climate Control Descriptions And Functions / Mode Control

Jeep Wrangler: Automatic Climate Control Descriptions And Functions / Mode Control

Jeep Wrangler. Mode Control Select one of the Mode buttons on the touchscreen or press the Mode button on the faceplate to adjust the airflow distribution. The airflow distribution can be adjusted so air comes from the instrument panel outlets, floor outlets, defrost outlets, and demist outlets.

Blower Control

Blower Control regulates the amount of air forced through the Climate Control system. Adjusting the blower will cause automatic mode to switch to manual operation...

Panel Mode

Air comes from the outlets in the instrument panel. Each of these outlets can be individually adjusted to direct the flow of air. The air vanes of the center outlets and outboard outlets can be moved up and down or side to side to regulate airflow direction...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: Lap/Shoulder Belt Untwisting Procedure

Use the following procedure to untwist a twisted lap/shoulder belt. Position the latch plate as close as possible to the anchor point. At about 6 to 12 inches (15 to 30 cm) above the latch plate, grab and twist the seat belt webbing 180 degrees to create a fold that begins immediately above the latch plate...

Jeep Wrangler 2018-2026 Owners Manual: To Manually Turn Off and Turn On The Stop/Start System

TO MANUALLY TURN OFF THE STOP/START SYSTEM Stop/Start OFF Switch Push the Stop/Start OFF switch (located on the switch bank). The light on the switch will illuminate. The “Stop/Start OFF” message will appear in instrument cluster display within the Stop/Start section, and the autostop function will be disabled...

Erasing All The HomeLink® Channels

To erase the channels, follow this procedure:

Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes.

NOTE:

Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming additional buttons.