Jeep Wrangler: STOP/START SYSTEM — AUTOMATIC TRANSMISSION (IF EQUIPPED) / To Manually Turn Off and Turn On The Stop/Start System

TO MANUALLY TURN OFF THE STOP/START SYSTEM

Jeep Wrangler. To Manually Turn Off and Turn On The Stop/Start System

Stop/Start OFF Switch

Push the Stop/Start OFF switch (located on the switch bank). The light on the switch will illuminate. The “Stop/Start OFF” message will appear in instrument cluster display within the Stop/Start section, and the autostop function will be disabled.

NOTE:

The Stop/Start system will reset itself back to an ON condition every time the ignition is turned off and back on.

TO MANUALLY TURN ON THE STOP/START SYSTEM

Push the Stop/Start OFF switch (located on the switch bank). The light on the switch will turn off.

    To Start The Engine While In Autostop Mode

    While in a forward gear, the engine will start when the brake pedal is released or the throttle pedal is pressed. The transmission will automatically re-engage upon engine restart...

    System Malfunction

    If there is a malfunction in the Stop/Start system, the system will not shut down the engine. A “SERVICE STOP/START SYSTEM” message will appear in the instrument cluster display...

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: Connected Services Vehicle Finder FAQs


    Can someone else locate my vehicle? Your vehicle may be located by anyone who has your PIN and access to your account. It is your responsibility to guard your PIN accordingly. See the Uconnect and SiriusXM Guardian™ terms of service for more information...

    Jeep Wrangler 2018-2026 Owners Manual: Data Collection & Privacy


    The Uconnect system collects and transmits data which may include information about your vehicle, your vehicle’s health and performance, your vehicle’s location, your utilization of the features in your vehicle, and other data. The collection, use and sharing of this information is required to provide the SiriusXM Guardian™ services and is further described by the Uconnect Privacy Policy, which can be found at www...

    Categories

    Turn Signals. Lane Change Assist — If Equipped

    Turn Signals

    Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation.

    NOTE:

    If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb.

    read more

     
    Copyright © 2026 www.jewrangler.com