Jeep Wrangler: STOP/START SYSTEM — AUTOMATIC TRANSMISSION (IF EQUIPPED) / System Malfunction
If there is a malfunction in the Stop/Start
system, the system will not shut down the
engine. A “SERVICE STOP/START SYSTEM”
message will appear in the instrument cluster
display.
If the “SERVICE STOP/START SYSTEM”
message appears in the instrument cluster
display, have the system checked by an
authorized dealer.
If a malfunction occurs during an autostop, the
vehicle may not auto start and will need a key
start.
TO MANUALLY TURN OFF THE STOP/START SYSTEM
Stop/Start OFF Switch
Push the Stop/Start OFF switch (located on the
switch bank). The light on the switch will
illuminate...
The Engine Stop/Start (ESS) function is
developed to reduce fuel consumption. The
system will stop the engine automatically during
a vehicle stop if the required conditions are
met...
Other information:
Automatic Operation
Push the AUTO button on the faceplate, or
the AUTO button on the touchscreen on the
Automatic Temperature Control (ATC)
Panel.
Next, adjust the temperature that you would
like the system to maintain by adjusting the
driver and passenger temperature control
buttons...
This
warning light will illuminate to
signal a fault with the 4WD system. If
the light stays on or comes on during
driving, it means that the 4WD system
is not functioning properly and that service is
required. We recommend you drive to the
nearest service center and have the vehicle
serviced immediately...