Jeep Wrangler: REFUELING THE VEHICLE — DIESEL ENGINE (IF EQUIPPED) / Bulk Fuel Storage — Diesel Fuel
If you store quantities of fuel, good maintenance of the stored fuel is also essential. Fuel contaminated with water will promote the growth of “microbes.” These microbes form “slime” that will clog the fuel filtration system and lines. Drain condensation from the supply tank and change the line filter on a regular basis.
NOTE:
When a diesel engine is allowed to run out of fuel, air is pulled into the fuel system.
WARNING!
Do not open the high pressure fuel system with the engine running. Engine operation causes high fuel pressure. High pressure fuel spray can cause serious injury or death.
Avoid Using Contaminated Fuel
Fuel that is contaminated by water or dirt can
cause severe damage to the engine fuel
system. Proper maintenance of the engine fuel
filter and fuel tank is essential...
Diesel Exhaust Fluid
Your vehicle is equipped with a Selective
Catalytic Reduction (SCR) system to meet the
very stringent diesel emissions standards
required by the Environmental Protection Agency...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: AUTOMATIC TRANSMISSION — IF EQUIPPED
You must press and hold the brake pedal while shifting out of PARK. CAUTION! Shift into or out of PARK or REVERSE only after the vehicle has come to a complete stop. Do not shift between PARK, REVERSE, NEUTRAL, or DRIVE when the engine is above idle speed...
Jeep Wrangler 2018-2026 Owners Manual: ONBOARD DIAGNOSTIC SYSTEM — OBD II
Your vehicle is equipped with a sophisticated Onboard Diagnostic system called OBD II. This system monitors the performance of the emissions, engine, and transmission control systems. When these systems are operating properly, your vehicle will provide excellent performance and fuel economy, as well as engine emissions well within current government regulations...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Engine Coolant Level — 2.0L
- SERVICING AND MAINTENANCE
- Manual Front Seat Recline Adjustment
- New on site
- Most important about car
Basic Voice Commands
The basic Voice Commands below can be given at any point while using your Uconnect system. Push the VR button on the steering wheel. After the beep, say:
“Cancel” to stop a current voice session. “Help” to hear a list of suggested Voice Commands. “Repeat” to listen to the system prompts again.